4G Converter kit - S

4G Converter Kit - S

4G Converter Kit - Sierra includes: Converter Box, Serial Cable, 2 Paddle Antennas, 4 Zip Ties and 2 Alcohol Wipes.

Limited Warranty for 4GC devices.   Zonar warrants that the 4GC Devices (4G converters to convert a Zonar V3 GPS unit to use 4G wireless data transfer service instead of 3G wireless service) shall be free from all material defects in workmanship under normal use and service for a period of 2 years (from the date of shipment).  

Install Video and Instructionshttps://support.zonarsystems.net/hc/en-us/articles/4404624222221-4G-Converter-Kit-Installation-Sierra-Wireless

Install Instructions:

1. Locate the V3 telematics control unit in the bulkhead area. NOTE: When upgrading a VTHU unit, refer to factory installation images for location of the telematics control unit.

2. Note the serial number located on the back of the unit and the asset number to later confirm in Ground Traffic Control that the converter installation is successful.

3. Plug the 8-pin cable harness from the kit into the converter box.

4. Turn the vehicle on to make sure a cellular signal is available on the V3.

5. Plug the other end of the serial cable into the 6-pin port on the V3 unit.

6. Use zip ties to manage cable slack.

7. Use zip ties to secure the converter box to the cable assembly.

CAUTION: Do not place the converter box directly on top of the V3 unit, other radios,  
or other sources of electrical noise. 
8. Remove the two red caps from the antenna ports on the converter box.

9. Attach the two antennas to the converter box at the coaxial terminals.

10. Secure the antennas in the bulkhead at least 8 inches apart from each other and 10 inches away from people:

a. Clean the surface with an alcohol wipe.

b. Remove the adhesive backing. 

c. Press the antenna in place to secure.     

11. Secure the V3 telematics unit in its mount.

12. Power cycle the V3 telematics unit by unplugging the 4-pin connector, waiting 15 seconds, then plugging the cable back in the device.

13. Check the cellular signal light on the V3 telematics unit. A red light indicates that the converter box is functioning and a 4G signal is present.